The flyer and bobbin start to rotate, thereby twisting the yarn. The difference in the spend will continually wind the yarn right onto the bobbin. The difference in speed or ratio is changed by the size of the whorls, as well as the tension of the drive band. The drive band on the double drive wheel is made of non-stretch twine or yarn. Link the leader to the drop spindle by tying a piece of yarn measuring around 18 inches long to the shaft just over the whorl. Take the yarn to the side of the whorl, then loop it around the shaft located below. Loop back over the whorl's side and secure the end to the hook. Start spinning by leaving the fibers at the end of the leader loose. After the war, the processes and manufacture of woven bamboos were stopped and replaced with the manufacture of cheap ones that were only made of plastic. But still, the public always wanted something that was natural and made with great quality. This was probably why they always came back to the use and high demand of woven bamboo products. Tie a single end to the wooden weaving loom, then stretch the length down, allowing the string to run down the long side, similar to a guitar. Tie the end of the string around. Make sure that the string is stretched and secured very tightly. Repeat the process until the loom gets full. Repeating the Process The one end of the color yarn rolls to the top at the far right or the far left side of the bottom. There are several ways and reasons why you should prepare your own fiber. Using prepared fiber, you can spin immediately. Choose medium-grade wool in batt or roving/top form. The fiber should ideally hang well when you hold it slowly. It should also include some air inside, like puff. Choose the best color, dyed or natural, then separate a piece of the fiber by pulling it free. The spindle can be turned and attached to a pulley that is attached to a bigger wheel, if not a few wheels. A single complete turn of the wheel is capable of turning the spindle a lot of times, just like what occurs to the gears that are attached to a bicycle. Each of these cycles only takes a few seconds.